http://ndgarrison.com/ndforum/ |
|
Up grading my bucket http://ndgarrison.com/ndforum/viewtopic.php?f=6&t=355 |
Page 6 of 9 |
Author: | Ruck [ Thu Dec 05, 2013 10:52 pm ] |
Post subject: | Re: Up grading my bucket |
I then took the mesh and laid the fan on it marked where to bend it then with a straight edge I bent it being careful to get as tight a bend 90 degrees as I could. |
Author: | Ruck [ Thu Dec 05, 2013 10:53 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 10:54 pm ] |
Post subject: | Re: Up grading my bucket |
Then I bent the other side the same way. |
Author: | Ruck [ Thu Dec 05, 2013 10:54 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 10:57 pm ] |
Post subject: | Re: Up grading my bucket |
I put the fan back inside to double check the fit and made adjustments as needed. Then I measured the sides to bend. I then had to cut two lines for the bend. |
Author: | Ruck [ Thu Dec 05, 2013 10:58 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 10:58 pm ] |
Post subject: | Re: Up grading my bucket |
But first I cut off the excess mesh always better to cut a little off then to not have enough |
Author: | Ruck [ Thu Dec 05, 2013 11:02 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 11:03 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 11:06 pm ] |
Post subject: | Re: Up grading my bucket |
In the picture above I cut right on the bend to allow me to bend that piece with out any over hanging piece, both are flat. |
Author: | Ruck [ Thu Dec 05, 2013 11:07 pm ] |
Post subject: | Re: Up grading my bucket |
Once I cut both sides I bent in both tabs over each other. |
Author: | Ruck [ Thu Dec 05, 2013 11:08 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 11:10 pm ] |
Post subject: | Re: Up grading my bucket |
Then I bent the other piece over the two pieces I just bent. |
Author: | Ruck [ Thu Dec 05, 2013 11:11 pm ] |
Post subject: | Re: Up grading my bucket |
Author: | Ruck [ Thu Dec 05, 2013 11:21 pm ] |
Post subject: | Re: Up grading my bucket |
Then I bent the tab that will go against the bucket and hold it in place. |
Page 6 of 9 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |