http://ndgarrison.com/ndforum/ |
|
| Upgrading My Bucket / Armor upgrade http://ndgarrison.com/ndforum/viewtopic.php?f=6&t=429 |
Page 1 of 4 |
| Author: | Ruck [ Fri Mar 21, 2014 12:54 pm ] |
| Post subject: | Upgrading My Bucket / Armor upgrade |
This post is part 2 of upgrading my bucket, but is now more focused on the armor part of the upgrade. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:02 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I have the Aker MR2800 and I mounted it in my chest and when I turned the sound on so you could hear me talk it would squeal pretty loud. I had to adjust the output to the wireless mic and the volume to the Aker but I still had the feedback at a volume you could hear me. I Took and moved the Aker down to my stomach inside my armor and that helped a little. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:03 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I took my Aker and put a thin rubber foam all around it except for the front that velcros to the armor. I got the foam from Grainger and it helped reduce the feedback a little more. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:03 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:05 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I also took the wireless mic and made a foam piece to go on the mic pickup. I took the foam piece off the mic that came with it and slid mine onto it. It's not 100% but it reduced the feedback now to a point where I can have the volume loud enough for people to hear me. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:05 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:06 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I put the wireless receiver in the back of my armor plate. I also have a Hyperdyne labs voice changer wired into the receiver and an on / off switch that controls the power to the system. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:07 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:11 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:12 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I have a push to talk wire that I run from the voice changer down my arm to my hand. I also run a wire from the voice changer to my Aker in the front of my armor. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:13 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I made plastic clips to hold the wires in place. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:14 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:14 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Author: | Ruck [ Fri Mar 21, 2014 1:15 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
I took and cut little pieces of that rubber foam and glued it inside the ridge part of the clips to hold the wire firmly but allow for movement. I then took velcro and attached it to the ends of the clips. I took and placed the other side of the velcro on the armor. |
|
| Author: | Ruck [ Fri Mar 21, 2014 1:17 pm ] |
| Post subject: | Re: Upgrading My Bucket / Armor upgrade |
|
|
| Page 1 of 4 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|